How to Build a Fire Pit
By: Leon Drell

Do you know what fire pit is? A fire pit is a dug out small pit where you set up a fire and hang out around and chat with other people around you. It is rather a fun and cozy method to get warm also at the very same time helps you increase your relationship with the individuals around the fire.

A fire pit has been used for alot of things for so many years especially outdoor activities like cooking and camping. Fire pit is not just for the purpose to thrive a good relationship with your camping mates. People oftentimes group up around a burning fire and chat about any topics under the beautiful sky. How do I create a fire pit has been one of the most asked topic of many camp fires but it generally tales some plannings of where to find the right spot for a fire pit to begin with. The position of a fire pit should first be considered far from any objects and structures especially things that might burn easily. Do not pick a place near any dried up plants or wood that are highly flammable as well.

Building Your Fire Pit

As explained earlier, before you plan to construct a fire pit, you have to find the right and safe spot first. Once you have found a good spot for your fire pit, only then you can begin to build it there. First, you must measure how wide the perimeter of your fire pit. Usually a fire pit should not be too big; the most ideal circumference or perimeter can be in a size of approximately one and a half foot.

creating fire pits are very simple if you have all the tools needed and ready in one place. There are so many tools you can use, but basically, you just have to have some digging equipment, some sand and some pea gravel. You will require some concrete blocks or pavers as well to surround your fire pit with. Building a fire pit is very simple as long as you‘re aware of the safety measures and procedures that you need to take.

Measure and put a mark on the place by drawing a rough circle on the ground. You can use a stone or a stick to do so. Once you‘re done with the drawing, you can now start with the digging. Dig within the circle lines until about one foot deep. At the center of it, you must dig one more hole and this time with a perimeter of around six or seven inches. It should be about eight to twelve inches deep.

Once you have finished all the diggings, it‘s time to fill up the holes. fill the holes with the pea gravel mentioned just now, and then start adding sands approximately three inches at the most top of the pit. The sand must be poured until it reaches the same level with the ground. Once it‘s done, you can now cover around the pit with either cement and bricks or stones, or concrete blocks or pavers. You must cover around the circle, not inside it. It would be more fitting if your bricks or pavers are at least 2 stacks high so that it can prevent any logs of burning sticks from rolling.

Article Source: http://www.ArticleJoe.com

Leon Drell is a dynamic young man who never stop learning new things. He runs a web site at www.profirepit.com to understand more about www.profirepit.com/“>fire pits and to improve, and at the same time, to share the knowledge with everyone else.

Please Rate this Article

5 out of 54 out of 53 out of 52 out of 51 out of 5 

Not yet Rated